Recent content by geoffw

SOLD

Sold

Asking $530 shipped OBO

Im parting out my entire drivetrain and going with a completely different setup. Everything below has got to go.....Feel free to make offers. -T45 Excellent Condition with 30k miles on it, comes with a Steeda Tri-Ax Shifter - $350 -03 Cobra 11lb Aluminum Flywheel - $125 -Spec Street...

These are brand new, open box. I opened them up and got ready to install them, then sold the engine. $200 shipped. -Geoff

03 Cobra Spare Tire - $100 Shipped (2) 17x9 Steeda Ultra-lite Chrome Rims (Like New) - $350 Shipped Thanks for looking, feel free to make reasonable offers! -Geoff

I just bought this kit and now I'am selling the car, so there's no need to keep this kit. Its got a fresh Garrett GT4088 Turbo (turbo is basically brand new, $1000 value.) Its a .72 AR Compressor Housing and 1.12 AR Turbine Housing. What you see is what you get. This kit ALSO includes an...

Im looking for some used Fore or CPR fuel rails that will fit with a Whipple 2.3. Iam going returnless and Im on a budget. Thanks, -Geoff

Im selling my Terminator Cobra street/strip car with the following mods: Powertrain & Performance: Whipple 2.3 Gen 2 Supercharger w/ 3.00” & 2.75” Pulley LFP Idler Pulleys Meziere Electric Water Pump SCT Big Air BA2400 Zone-5 Stage 1 FPDM Dual Ford GT Fuel Pumps Fluidyne Radiator Afco...

Long story short and sweet: Got in it to try to start it, hit the ignition and then my finger slipped off the key so it bliped. Tried to start it again..NOTHING (not even a click from the solenoid). Found 40A Starter fuse #3 had broken. Replaced the fuse and tried to start the car and the...

My High Maintenance POS is at it again! This time it wont start. I got in it this morning and cranked it, it cranked for a few revs and then my finger slipped off the key. I went to crank it again and nothing happened, not even a starter click! I was thinking a battery, but it seems to be...

I just got a Hellion kit without the K member and of course I need a tubular K Member, but do i also need to get the coilovers and a-arms with the K? Aside from extra cost, I want to keep my Kenny Brown suspension and stock A-Arms since its a street car. Thanks, -Geoff

Check out the new toy thats going into the E.Green 99! Its got a GT4088 turbo and once my built motor is longblocked then Ill start putting it togethor. Im looking to make 800+rwhp on 100 or e85, any suggestions on what blow-through MAF setup to use? I was considering the HPX PMAS in a...

Please PM me if you have one for sale, I need an extra to go with my Hellion kit. -Geoff

ASking $100 + Shipping