Hi
I normally dont show my work on here, primarly because i always forget the camera :rolling:
Well any way I decided to day it was time to freshing up the brakes on my cobra and just wanted to show you the results.
Sorry for crappy cell phone pictures
Then i used this :-p...
Hello
I'm building an engine (for my 2001 cobra and doing a eaton swap at the same time) and cant decide on the compression ratio.
I currently have a stock eaton with a 2.80 upper
Would it be a problem to raise the compression to 9.1
Consindering i'm running 99 octane at the moment...
Hey Guys
I need a little help..
My dad recently bought a 1980 Mustang (5.0 L) and there is missing a door molding at the driver side.
I'm new to this type of mustang (i own a 2001 cobra) and therefore dont know any places where to get this type of molding.
Hope you can help me...
Hi
I might have got my hands on a very nice 03 cobra block:banana:
- Which is going to be build with diamond pistons, manley rods and so on.....
I was just wondering is there anything that dosen't fit or is all a direct replacement??
Thanks,
Dennis
Hi i just recieved my Aquamist 1S kit and DDS3 Gauge today and i wanted too share with you guess...
I think it is going to be nice...:thumbsup:
I will post pictures when i have installed it....
Quater Mile - Vortech/Prochager
Hi Everyone.
Just want to ask all you guys who run a Vortech or a Prochager setup.
Here in Denmark we soon will have a competion about who is the fastest car in Denmark. (take place in May)
I'm in the competition (not going after the 1. place ;-))
I...
Hello Everyone
I'm a new member of this forum.
I recently bought (about 6 months ago) a 2001 Cobra from USA and had it shipped to my home here in denmark.
The car looked like junk and I'm currently making a restoration.
I currently working in the engineroom right now.
I installed...