OK so I'm looking for a tuner that has knowledge of tuning my 2000 twin turbo 2v with moates quarterhorse software? Any suggestions will be appreciated
All of the following parts came off of my 2000 mustang gt.
281 iron block.$50
Large paxton intercooler $400.00
01-04 march pulley set $75.00
94-04 single pillar pod black $20
Stock gt throttle body $ 15
Sytock water pump $50
2 Bosch o2 sensors $50
Chrome billet fuel door $25
Centerforce throw...
Ok guys so thinking about going turbo over the winter. Ok couple questions old setup was built for a supercharged application. Current setup is a mmr 850 5.0 stroker livernois stage 2 heads which mmr did their stage 3 port and polish on and comp xe278's with a cr of 9.5x1 its a 2v btw. First...
So back in december of 09 I sent my novi 2k in for a rebuild to vortech. Cost me 1200$ dollars for the rebuild. Got it put on the car in may along with my brand new motor from mmr. Well on may 20th -23 took it down to ocean city for mustang week. The blower pretty much exploded cracked the...
Hi I'm considering in purchasing a hellion single 76mm. I'd be switching from a supercharged setup to a turbo setup. Current setup is a novi 2k with a mmr 850 5.0 stroker stage 2 livernois heads which mmr did there stage 3 port and polish on with comp xe278 cams. it currently has a compression...
Does anybody know any good places around or close to pa that does a bang up job wet sanding polishing etc. Only places I could find were located in cali. Thanks for all the help shaun
So a couple months ago I ordered a mmr 850 5 liter engine with a compression ratio of 8.5.1. Long story short I ended up getting my engine with a 9.5.1. The car is blown with a novi 2k which I recently sent into paxton and had rebuilt. It was putting out 15psi on old setup on pump gas. O really...
All you guys with big hp and tq cars chime ine please. I recently purchased a motor from mmr and I know I'm gonna go over thr maximum tq rating of the tko. Any of you high hp tko out there any help would be great thanks,shaun
Does anyone know if anybody makes a triple pod gauge for a a2000 gt vert I know that they make them for hard top but can't seem to find any for the verts any help would be appreciated thanks, shaun