Recent content by Cobragixxer9994

Does anyone have the wiring pinout/diagram for a 99 cobra transmission harness ? Sent from my SM-N981U using Tapatalk

Up Sent from my SM-N981U using Tapatalk

Up Sent from my SM-N981U using Tapatalk

Are the pivot stud the same between t56 and t45 Sent from my SM-N981U using Tapatalk

Does anyone know a part number for the output shaft seal . I bought a timkin 710426 and the seal inside diameter is too small even though it's listed for t56 Sent from my SM-N981U using Tapatalk

The steel one weighs in at 16.7 lbs If that matters Sent from my SM-N981U using Tapatalk

Stock redline I take it to about 6k Sent from my SM-N981U using Tapatalk

Should i run Aluminum or lightweight steel flywheel ? Drag racing/street driven Vortech around 540 hp drag radials irs Does this look like it needs to be resurfaced ? Sent from my SM-N981U using Tapatalk

He'll yea its the next step I could take aside from doing forged internals I'm already at 500+ to the wheels I received the trans today and everything looks great except it has an adjustable pivotball which I don't know how to set bit I'm sure there are write ups Sent from my SM-N981U using...

Ok cool thank you my t56 arrives tomorrow I can't wait to get started Sent from my SM-N981U using Tapatalk

Thanks for the responses Will I have to correct my speedometer when I do the swap Sent from my SM-N981U using Tapatalk

Still have the t56 swap

Everyone's thoughts on viper spec t56 compared to t45 with 4.10 gears and and vortech si 14 psi. Will it be slower ? Yes I have searched but I come up with a ton of mixed reviews. Edit (running 26 inch drag radial) Sent from my SM-N981U using Tapatalk

Responded Sent from my SM-N981U using Tapatalk

Can anyone measure the inside of there 17 inch cobra wheels ? I'm getting roughly 15 toward the face of the wheel. Do all cobra wheels have a taper to the inside barrel ? Sent from my SM-N981U using Tapatalk