So Ive been really tired of all the clunking, creaking, squeaking etc coming from my suspension -- especially since none of its very old. Today, I took care of the rear.
Heres my setup:
MM LCAs (less than 2k miles)
New factory UCAs
Bilstein HDs
Steeda Springs
Stock sway bar
No isolators
While...
it was a nice time... There was a lot of junk there.. I saw lots of colored wire loom... :/
My junk at the show all clean
Bill
I need an eaton setup... anyone selling a kit :D?
Harrisburg Pa
I think its free.. Its in Harrisburg like 9am-2PM
My car will be clean by then for the American Muscle show the next day. Anyone wanna go to this one?
Bill
Get ready for CJ’s 11th Annual Customer Appreciation Day! | CJ Pony Parts
I bought the HD version, non-adjustable LCAs. The ones with the spherical at the axle, Poly at the chassis
Well the rear end of the car suddenly got wild a few days ago. Popping and floating all over the place. Car was scary to drive... Looked under it twice and couldnt find the source. Took it...
I just installed new pads and rotors on the mach. The drivers side rear pad does not seem to be making a full contact patch with the rotor. The outer pad seems to only be fully contacting the outer 75% of the rotor.
Are the rear caliper brackets known for bending/deforming. I had a constant...
Im still strongly considering an IRS swap for my mach. Id do it if i found the right car and one close to me
What I have:
04 8.8 with 50k miles
Fully welded tubes
Maximum Motorsports HD LCA's (less than 7.5k miles)
New factory UCA's (less than 7.5k miles)
4.10 gears
Brand new Bilstein...
I have a blackout panel for a GT. The ones that goes on the trunk. Its in excellent condition and comes with a FORD and a GT emblem already on it. Was on my old car for less than 6 months. Includes new 3m adhesive tape for install
$150 new
yours for $75 obo plus the ride
not my car but this...
Just sharing a little work i did this weekend.. My mach has been riding like total crap.. likely due to the absolutely shot factory struts and shocks
the mach got brand new bilstein HDs at all 4 corners (my tokico factory struts would collapse with light pressure from one hand), a MM steering...