Recently had my fuel pump replaced. Went to fill up with gas ( tank was on a 1/4) and gas stops pumping almost as soon as it hits the tank, like the tank is already full, when I know it isn't. Took about 10 mins to get a half tank of gas in the car. I suspect it may be the evap canister, but not...
Been awhile since I've been on here but could really use some help...
So my 01 has been sitting for about a year now (why is not important) and has not been started in that time. It sits outside because I don't have a garage. I replaced the battery yesterday and went to start it up.... no...
Just posting up a pic with a 3/8" intake spacer on..acceleration is definitely more responsive in the lower to mid rpm range and much smoother in the lower rpm range... :burnout:
The other pic is of my lower intake, 3 yrs after installing the JLT pre-filters and running Seafoam through...
Question about the X Cal 2....What is the engine rpms setting for on the x cal 2 and where should I set it at? Should it be set at 800 rpms just like the idle? I have the idle set at 800 btw... thanks new edgers!
Need to get the True Blue 01 looking good for this year...what would you recommend as the best products for this color of paint? Polish, wax, SD, claybar, mf towels, soap ...etc. The whole works. I know this color is on par with the blue in the mystichrome paint shade-wise, but wasn't sure if...
Alright guys help me out here..
I'm driving along about 30-35 mph when all of a sudden I hear a very loud pop up front on the driver's side. I then begin to feel this slight vibration in the floorboard on the driver's side. I can also hear a faint rubbing noise when the car is in neutral...
Get your money together, dig in your couch for loose change, because this has got to be one of the best sales I have seen in awhile!!!
KarKraft GOING OUT OF BUSINESS SALE at their Livonia, MI location only. Sad to see it happen, but I see some SWEEET deals already!!!
Garage Sale
Cheap...
When replacing a front wheel ABS sensor, is there any sort of reset of anything that needs to be done? Or is it a simple replace and go?
Thanks guys...
I need to replace my front drivers side ABS sensor. The wire got chewed through by the inside of my wheel :fm: I think my sleeve must have pulled on the bracket when I was in there checking things out during my winter wheel swap and didn't realize it had happened until it was obviously too...
My drivers side door is sagging pretty badly. I can see how it has to travel upwards when I close the door. How do I fix it? Do I need new hinges or is there an easier way to fix it?
Thanks for any input guys
Can anyone verify if this is the Ford part number for the 90mm MAF?
1L3F-12B579-AB
AFH90-02
4C31
This is right on top of the sensor where the harness plugs in
I'm looking to buy one of off a member on here and want to make sure I am getting a 90mm and not an 80mm, since I can't tell...
I am installing Steeda x2 ball joints today...how many of you who are running with the Eibach pro-kits used the spacers? Will it make that much of a difference in front end suspension performance if I don't use them? I could use the additional 1/2 " drop up front, but want to make sure I'm not...