Selling a set of basically brand new Maximum Motorsports CC Plates for any 2015+ Mustang.
These were installed and then removed the same day after going with a different setup.
Bought brand new for $247 from CJ Pony Parts, asking $200 shipped obo
Has anyone ever covered their backup sensor holes with some kind of plug? I am having my Roush Rear valance installed today along with my corsa extreme quad tip and didnt notice that the valance was predrilled for backup sensor holes and i dont have backup sensors :fm: has anyone ever filled...
Just got my Corsa Extreme Cat-Back yesterday and i noticed on one of the mufflers there is a small "punch" hole in it nearest the weld seam closest to the edge.... is this a flaw or a hole to let moisture out? anyone else have this problem? my other muffler doesnt have this issue, only 1...
Does this happen to anyone else? I'm new to the Coyote crew so i'm trying to learn these engine's/trans.
I have a 2016 Perf. Pack GT 6 speed and everytime i upshift (1-2, 2-3, etc) it sounds like the trans in "thumping" for lack of better terms. Car only has 1,000 miles on it. Curious if...
Brought my junk to Power By The Hour Performance for some upgrades and retune by Ken Bjonnes @ Lund Tuning. Looking forward to getting it back next week sometime and seeing what she makes.
Modz:
Built Motor
Vortech V1-Strim 2.76 pulley
Ported Heads
Bullet Custom Cams
Kooks Longtubes/X...
I picked up a Optima Red top last night for my 00 GT, and as most people have said it doesnt fit in the tray properly, but my bigger concern is that it doesnt clamp down with that plastic block & screw. It tends to slide around and wobble a bit.
How did you guys get yours to stay firmly...
Hey Guys,
I'm trying to brush up on my knowledge of the new 5.0. I've always been a New Edge Owner, so my knowledge of that car is good, but i really know nothing about the new 5.0 so i'm hoping people can chime in and educate me.
I am planning on getting a '15 when it comes out but in the...