Recent content by 98Cobra2020

Every part on the car is new that is why I didn't list them..

Ok yall, I am back to the drawing board not sure which way to turn now. I have changed everything on this 98 mustang cobra and I mean every single part on the car is brand new. My fuel pump will not come on at all first issue and 2nd issue is when I turn my key on it does nothing but I have...

Yes it's been changed by me. Everything is connected it just won't turn over someone said my neutral safety switch could be messed up.

I am going to change my ignition lock cylinder on my 98 cobra, however they sell them with or without the transponder keys. I have bypassed my PATS system with my tuner, therefore can I use a lock cylinder that is without transponder keys?

I changed the switch module box and not it won't turn over however everything in car comes on and I can jump starter this is a manual transmission also. When it starts after jumping starter it cuts off like there's a fuel issue.

Did u have this problem as well?

Ccrm has been changed its brand new.

Replaced the hat and pump. Not talking about fuse box talking about the box under steering column that controls the starting of car with key switch.

I am getting code P0230 Fuel Pump Primary Circuit Malfunction. My fuel pump is brand new and my gas gauge will not work now I am guessing because of this code. Another issue that I am having is I replaced the switch box under my dash and now my car won't even turn over. Any advice with the...

My 98 Mustang Cobra will sometimes sit an idle and other times it will cut off just as soon as I start it. I have replaced the fuel pump, however trying to figure out the issue. My fuel hand worked great up until I changed the fuel pump. Also, when I do keep it running and try to drive in my...

So today my car starting sputtering, and cut off a few times. All my gauges were working properly. I changed my fuel filter and fuel pump assembly today as well thinking that was problem, then my car starting over heating and the fuel gauge stopped working as well. All other gauges are working...

I'm talking abt hood spacers to get my hood to clear my intake tube

My car is supposed to run 5w30 after my break in oil what viscosity is safe to run and what brand of of zinc oil do yall recommend?

Do you have a pic of what they look like please? Would I put them on the bolt on my hood itself?

Anywhere I can find a hood already painted white..