Recent content by 96snake1

Woa, I never thought it was that much. I use 7qts and change the oil every 3-4 months regardless, but Ive never noticed it being a quart low. It does kind of make sense, seing how my oil separator (steeda type) gets almost filled about every 500 miles it seems like.

I actually thought about doing just that. Ill definitely try that if I feel the car is acting different

Sup guys!? Havent been on in a while and im probably beating a dead horse, but still have to ask. I recently changed my oil and went to full synthetic 10W30. Now I am a Ford tech turned accounts manager(lol) so I know these cars had 5W30 as the recommended viscosity, but accoriding to the shop...

Havent got the chance to really open it up under load, but wot at idle sounds a little bit quieter than my MAC set up with true duals. The thing that really sets it off is the even tone. I would say is 75% of the SLP1s as far as noise but much better sound.

Thanks for the heads up on the Xpipe, good advice...to be honest, its really not all that loud compared to the MAC set up i had before. I would say its same level with a smoother tone and surprisingly very little drone. I only drive it once, maybe twice a week.

Update...got the exhaust done. Highflow cats to full 3" pipping, weld in xpipe, to the Pypes M80s...couldnt have made a better choise. Sounds freakin awesome!

Update!! Dropped the trans ( had to remove bank2 header) and it was in fact a bad throwout bearing. Clutch release fork was kinda worn too so i replaced it as well. Used a premium throwout bearing though, not the one that came with the clutch. New pilot, and rear main seal. Noise gone...

Lol i went through the same thing with my 02 GT and finally landed on Flowtech afterburners...sounded awesome with the o/r x pipe...its my first 4V mustang so kinda wanted to get some good advise instead of changing set ups like my GT. At the same time i wanted a different sound to set mine...

Lol yeah im not trying to drive around with farm truck exhaust...got the x pipe

I thought about that or borla but it seemed to common for me..decided on going with an X pipe and Pypes M80s well see how it sounds lol

Do you think if i add an x pipe it would add some performance?? Dont really want spend money on it just for sound..

Im doing away with my MAC mufflers and cant decide which bullet style muffler to get between the Magnapacks, Dynomax race bullets, or Kooks race series.. have longtubes with full 3" pipping, true duals(no x/h pipe)...dont ask, i bought it like that, but it sounds pretty good.lol...what do you...

I went ahead and ordered a new clutch kit and flywheel which i will install thursday or friday, so i will have a look at the transmission input shaft. Just really hopping i dont have have a bad trans, since ive read some stuff about bad input shafts on t45s..

So about 4 months ago i started hearing intermittent noises (rattle with some chirping) from inside the bellhousing of my t45 that would go away at times when depressing the clutch or on its own. Sometimes it wouldnt go away even depressing the clutch pedal.. now its worse, it does it all the...

What mods did you need to do to fit the terminator radiator?