Went ahead and ordered a different one on ebay that is confirmed that style plug and 3 bar. Seller even put the reference volts for psi in increments. I'll wire that in when I get it and report back. Good chance this sensor is just a junk/1bar one.
Edit: I think I was able to finally wrap my...
I may have just realized what the issue is, this may not be a "3 bar" sensor, looks like a generic MAP sensor, could be a 1 bar or 2 bar, however others that look identical on amazon ARE listed as 3 BAR...
Still doesn't make sense that it would read 5v when the car is off unless the sensors are...
Affirmative. It's a 3 BAR knock-off GM replacement, the part number matches the GM/ACDelco part. See amazon link.
Suppose I could order another and swap it out, the pigtail is already wired in.
Actually I can't, looks like the pigtails on most of the GM ones are male pigtail and female on...
Hey guys,
I’m having an issue with a newly installed 3 BAR MAP sensor reading incorrect values in Live Link, reading super high and pegging out. Using analog 2 on the firewire (red) as my wideband is on analog 1 (orange). The setup is:
Boost line teed off from factory yellow boost line in...
Hopefully this is all it will be. I almost changed the engine coolant last year.. Glad I waited now I have a good excuse to do it haha.
They are the original, 18 year old gaskets that have been through a lot of cold winters and heat cycles.
Yeah I've tried that before when I had a very slow oil leak and it solved it, this seems to be a different spot. The oil was leaking at the junction of the oil cooler to the motor, this seems to be further outwards towards the filter.
Hey guys,
Noticed a few days ago there was some fluid leaking under my car. It's been put away for the winter, and we recently had some absolutely frigid weather here, as low as -10 F. I noticed the fluid right after this cold blast.
Finally did some preliminary diagnosing, and it appears to...
I did that trick to make sure the switch was working, and success. Everything is rewired and seems to be functioning as expected.
Inertia switch works again.
I reinstalled the FPDM and soldered a wire into the BK/PN (black w/ purple stripe) wire and I use that as my trigger wire. Is that how...
That's what I was thinking, how on earth could that switch run power through it if it is popped? Something must be wired backwards or the switch is bad.
I'm not sure how I would go about testing the switch. I could run a resistance/ohms test on it somehow but I'm just not that savvy with...
Also, how are you guys running your primary remote pump power? Mine is off the inertia switch. As I described earlier, my inertia switch works in reverse so if you push the button to reset it the car shuts off and if you whack it with a hammer and pop it, everything runs. I want to fix this, I...
It was a combination of that and "I can't believe I've been driving on 1 pump for 4 damn years".
I just ordered my Hobbs switch. Justin sent me a PDF file of how they recommend wiring it. Basically solder one of the wires from the Hobbs to your 12-volt power wire for your primary remote one...