I have eibach springs in the rear and upr coil overs in the front. I never tried shortening the hangers I just put a set of 18 inch rovos on my car and no more scraping. Before that I had to leave a 2x4 by my garage door so I didn’t scrape.I found it was my springs more than my exhaust. Had Eibach and switched to H&R.
You may be best off to shorten the hangers like 03DSG mentioned.It's a 01 cobra with Flowmaster tubing and cut in slp 2.
If it’s an irs cobra it should just have two bends straight out the back no axels to go over.Might have to take a half inch off the pipes as the go up over the axle as well. I know my Borla has a slip joint there.
Oh yea, duhIf it’s an irs cobra it should just have two bends straight out the back no axels to go over.