I just did the basic bolt ons on my 13, used the VMP 2.4 upper and their 90mm idler. It definitively is already creating alot of belt dust and I can smell it burning after a few hard accel runs. I never had belt dust before and you can see alot of powder around the sc snout after only a few hours of hot driving. Ive only put 400 or so miles on it so far with the pulley upgrade so the belt will surely be toast in no time. It is however the factory belt that has 20,000 hard miles on it and it is now 7 years old. I dont know if it just needs replacing because the belt is old... I would like to get a gates blue one. What have yall had good experience with? I am still running the factory tensioner. Thanks
Ditch the VMP pulley. My VMP pulley caused all my problems. Same issues with dust and was losing lots of boost. I put a BPS on and of all the mods I did to fix belt slip, that seemed to be the most effective.
That being said, I have run the Gates Racing and RPM belt which are the same as the blue which no longer exists. Id say I still feel those belts are too hard and to stick with a green belt. If I were to change anything again, i'd probably go with the Griptech and a green belt, but I don't think I am going to see any better than what I am now to be honest.