I've looked into the PCV system and fixes for lightnings for while now, and I'll admit it, I'm probably stupid and am missing something obvious...
Sorry in advance as i know the PCV system has been talked about dozens of times and I'm beating a dead horse here, but I'm just really frustrated and have no idea what's going on after reading for hours on PCV discussions... I currently getting tons of oil in my throttle body and intake tube, even enough for it to drip past the line between the driver side valve cover and intake. I put on trick flow valve covers (which I heard cause nightmares, but they have a baffle in them), performed the turkey pan mod, and placed a JLT separator between my passenger valve cover and upper intake (diagram of current setup attached).
Is there a reason I'm getting so much oil from here? Is it possible traveling from my intake, pooling up, and gravity then taking it to the throttle body? I would not think this is the case as I have the oil separator in line... Do I need a 1 way PCV valve on the driver side? I'd also think this wouldn't be necessary as the throttle body should be either closed and forcing air into the driver side PCV, or open and pulling air from the 5" Intake tube and not the small line... I've cleaned my intake and throttle body multiple times and I will probably have to clean my intercooler again.
It also does feel a bit rough on startup (possible misfires from pooled up oil being sucked in and coating my plugs, etc.)?
Below are also my compression test results (unfortunately my leak down test adapter wouldn't seal properly and I probably could have gotten slightly higher numbers if I let it crank more)
Tested when cold, no oil:
Cylinder 1:
- NO TEST, STRIPPED PLUG (since fixed and tested similar to rest)
Cylinder 2:
-160
Cylinder 3:
-170
Cylinder 4:
-170
Cylinder 5:
-165
Cylinder 6:
-165
Cylinder 7:
-175
Cylinder 8:
-180
Sorry in advance as i know the PCV system has been talked about dozens of times and I'm beating a dead horse here, but I'm just really frustrated and have no idea what's going on after reading for hours on PCV discussions... I currently getting tons of oil in my throttle body and intake tube, even enough for it to drip past the line between the driver side valve cover and intake. I put on trick flow valve covers (which I heard cause nightmares, but they have a baffle in them), performed the turkey pan mod, and placed a JLT separator between my passenger valve cover and upper intake (diagram of current setup attached).
Is there a reason I'm getting so much oil from here? Is it possible traveling from my intake, pooling up, and gravity then taking it to the throttle body? I would not think this is the case as I have the oil separator in line... Do I need a 1 way PCV valve on the driver side? I'd also think this wouldn't be necessary as the throttle body should be either closed and forcing air into the driver side PCV, or open and pulling air from the 5" Intake tube and not the small line... I've cleaned my intake and throttle body multiple times and I will probably have to clean my intercooler again.
It also does feel a bit rough on startup (possible misfires from pooled up oil being sucked in and coating my plugs, etc.)?
Below are also my compression test results (unfortunately my leak down test adapter wouldn't seal properly and I probably could have gotten slightly higher numbers if I let it crank more)
Tested when cold, no oil:
Cylinder 1:
- NO TEST, STRIPPED PLUG (since fixed and tested similar to rest)
Cylinder 2:
-160
Cylinder 3:
-170
Cylinder 4:
-170
Cylinder 5:
-165
Cylinder 6:
-165
Cylinder 7:
-175
Cylinder 8:
-180