• Welcome to SVTPerformance!

XCal2 Tips? What parameters to log

Discussion in 'Turbo Cobras' started by 04SilverSerpent, Apr 30, 2008.

  1. 04SilverSerpent

    04SilverSerpent ZTP Established Member

    Messages:
    1,038
    Joined:
    Oct 2, 2004
    Location:
    DFW TX
    I'm new to logging with the Xcal2...i've looked at the various parameters that can be logged. Can anyone give me some help here? I'm looking to log Injector Duty Cycle, Fuel Pump Capacity (ie how hard is the fuel pump working), Throttle Position, Intake Temps and a few other things.

    I'm assuming that "Spark" = timing and obvious parameters like "Coolant_Temp" and "Vehicle_Speed"under the environment heading, "RPM" under Misc heading.

    Can the XCal2 log boost at all given the car has a built in boost gauge or do you need a map sensor for that? I'm also looking to have my wideband configured so that I can log a/f as well. Anything else that I should consider when logging?

    Thanks,
     
  2. TRBO VNM

    TRBO VNM Authorized Vendor Authorized Vendor

    Messages:
    23,096
    Joined:
    Feb 5, 2004
    Location:
    Maryland
    coolant temp
    spark
    load
    fuel pump duty cycle
    alternator voltage
    rpm
    intake air temp, you want IAT2/MAP, but I don't recall the exact parameter name.
    throttle position absolute
    short trim fuel bank 1 and 2 or it may be bank 0 and 1

    I know there are a couple others, I don't recall right now.
     
  3. 04SilverSerpent

    04SilverSerpent ZTP Established Member

    Messages:
    1,038
    Joined:
    Oct 2, 2004
    Location:
    DFW TX
    Thanks..i'll have to look again for the fuel pump duty cycle as i didn't see that last time I went through the different paramters.
     
  4. Chris Barnes

    Chris Barnes Member Established Member

    Messages:
    32
    Joined:
    Feb 1, 2007
    Location:
    Phoenix, AZ
    spark source
    fuel source
     

Share This Page