WTT Comp cams 106360's

nsampson

go fast parts buyer
Established Member
Joined
Dec 30, 2012
Messages
66
Location
southern indiana
I have a set of lightly used comp cams 106360's I would like to trade for smaller cams. Something along the lines of comps 106100's would be nice.

I picked these up used and put them in only to find I don't have the ptv clearance to run them.
 
Last edited:

Quicktime_GT

Active Member
Established Member
Joined
Nov 22, 2006
Messages
2,243
Location
KY
You sure they clearance is going to be an issue?

Intake Exhaust Intake Exhaust Intake Exhaust LSA Intake Centerline Exhaust Centerline Int Open BTDC Int Close ABDC Exh Open BBDC Exh Close ATDC Overlap

106360 230 232 0.475 0.450 116 116 116 <-1> 51 52 0 <-1>
 

nsampson

go fast parts buyer
Established Member
Joined
Dec 30, 2012
Messages
66
Location
southern indiana
I'm sure its an issue. Flat tops, no valve reliefs, cams at 114/118 I got .033 ptv clearance. Way too close for me. I picked these cams up used after my short block was done hoping they would work. Poor planing on my part but I'm learning a lot from this engine build.
 

Users who are viewing this thread



Top