For sale is a used 2.5" Dynatech x-pipe for use with their longtube headers on any 2005-2010 Mustang GT or GT500. It is pictured in the off-road configuration without cats, but I am also including a set of high-flow cats that are easily swapped into place. The Dynatech part numbers are 122-543300B and 122-543300C, and the catted version sells new for $565. This was on my car for about 800 miles and only saw rain twice. As you can see in the pic, they do show some discoloration, as all stainless exhaust will. This x-pipe bolts right up to the factory catback exhaust or any aftermarket 2.5" exhaust. I'm selling it because I ended up swapping out for the 3" version. In my opinion, the Dynatech longtube headers are the best available. The hangers have been cut off, as Ford stopped using them after 2007 (at least on the GT500, but I'm not sure about the GT). Either way, the hangers are not necessary on these cars. Asking $300 shipped OBO.
WTS: Dynatech X-pipe
- Thread starter rodfarva
- Start date
PM sent
pm if this setup would work on my brothers 10 GT without the LT's.
Will this fit kooks longtubes?
If it does consider it sold
If it does consider it sold
Users who are viewing this thread
