Wiring MAP sensor for aeroforce gauge, need switched 12v

[Bud]

Anybody have suggestions for the easiest/best place to grab 12v switched under the hood for a map sensor install? Possibly a specific fuse in the box? Also on the same subject if somebody has run a pressure gauge on a roush s/c kit where did you tap in for a pressure reading? I'm thinking the nipple on the back of the manifold on the passenger side, any other suggestions?

I did get aeroforce's 5v regulator so any switched 12v should do.

Thanks

 

[Turbosixx]

I wired the map to the intercooler pump feed. It was switched 12v protected by a fuse and doesn't affect the IC pump.
I tied the vac lines to the port on the TB elbow. Put a tee there.

 

[Bud]

I wired the map to the intercooler pump feed. It was switched 12v protected by a fuse and doesn't affect the IC pump.
I tied the vac lines to the port on the TB elbow. Put a tee there.

Right on, thanks for the info man

 

[SaleenGT2001]

i used a add a fuse in the fuse box under the hood and just tee'd off the vacuum line to the bypass on my KB.