Wire tuck? Whose done it? Tips?

[robrbn]

Order a CPR turbo kit and thinking that when I install it I'd like to do a wire tuck to clean up the engine bay. Anyone done it and have any good tips for where to locate fuse box, pcm, etc. Also, does it require a lot of lengthening of wires or is there a decent amount of slack in the harness to relocate?

 

[2003mach1]

I'm right in the middle of it. I put the fuse box under the right headlight and the pcm on the a-pillar behind the tire. I routed the engine harness out the rear of the engine.
90 wires to extend. Lol

 

[jn2]

http://www.svtperformance.com/forum...e-box-battery-and-ABS-relocate-*lots-of-pics*

 

[robrbn]

I'm right in the middle of it. I put the fuse box under the right headlight and the pcm on the a-pillar behind the tire. I routed the engine harness out the rear of the engine.
90 wires to extend. Lol

lol sheesh... don't know if I have the patience for that

http://www.svtperformance.com/forum...e-box-battery-and-ABS-relocate-*lots-of-pics*

thanks man. i had seen that thread - was just seeing if anyone else had some tips/suggestions for the easiest way to get it done.