Whipple big bore elliptical

[Bonedriver]

Looking for values for prp sct to set for Whipple big bore elliptical tb.

thanks

 

[decipha]

what kind of values? do you have electronic throttle control?

 

[Bonedriver]

what kind of values? do you have electronic throttle control?

i am trying to get the ECT file values. I loaded the cobra jet file to get close. Tps volts are looking good and response isnt bad considering im using jlt super big air

 

[Bonedriver]

what kind of values? do you have electronic throttle control?

Yes i have etc control now. I was trying to setup eta and open loop. I found values for the super cobra jet mono which says flows 1797 cfm and the whipple which flows 2750 cfm. I scaled the eta table by the inverse difference 1.53. I then reset the open loop ta prediction table based on the average values from eta and then inversed math each value in that table. Not sure if i did all this correctly! Cant find a value table for the whipple super big bore. Guys i have talked to just use the sc jet values but thats a huge flow difference. Thanks for any help!