Which Caster/Camber Plates & Adj Tie Rod Kit?

[avj75]

I just lowered my car using the Eibach Pro Springs (1.5" in front and 1.7" in rear) I need to get some adj caster camber plates as well as an adj tie rod ends to get the front end aligned up properly. in your experience what's the best to buy in these two areas? Thanks.

 

[6-Speed]

I'm going with the Maximum Motorsports camber plates.

 

[Grunnsetning]

I like my J&M plates a lot.

 

[skyhighsd]

I just lowered my car using the Eibach Pro Springs (1.5" in front and 1.7" in rear) I need to get some adj caster camber plates as well as an adj tie rod ends to get the front end aligned up properly. in your experience what's the best to buy in these two areas? Thanks.

Same set up I have and didnt need anything to get it into spec on a laser rack.

 

[avj75]

skyhighsd, lucky you b/c I have noticeable negative camber going on right now that needs to be addressed.

 

[Q8_Shelby]

I like my J&M plates a lot.

+1000
:rockon:

 

[03 DSG Snake]

I installed MM plates on mine.

 

[sgt d]

lowered here and did not need anything
:shrug:

 

[Spawn]

I just used the camber bolts and set them at the maximum and have had perfect wear and never stuck it on a rack....

 

[avj75]

For those of you that have either used the M&M or J&M caster camber plates have you noticed any increase in your vehicle noise d/t the change in bushings??