Seeing if theres any good mechanics that won't charge an arm and a leg to build my cobra. Parts that I need installed are as follows:
Engine:
Manley Pistons with stock rods
Crower Stage 3 Cams
Heat Exchanger
Metco 4lb lower
Transmission:
Spec stage 3+ clutch
Aluminum Flywheel
26 spline input shaft upgrade
(pilot bearing, release bearing)
Rear End:
MM Aluminum IRS bushings
MM Subframe Connectors
Ford Racing Diff Cover
3.73 Gears
Overhaul trak lok with cf clutch
I will supply all the parts just need someone to install them. Would also get my fuel upgrades and blower swap done, but I'd rather not drive to my tuner without a tune. I would just get it done by him to get it tuned right away.
Engine:
Manley Pistons with stock rods
Crower Stage 3 Cams
Heat Exchanger
Metco 4lb lower
Transmission:
Spec stage 3+ clutch
Aluminum Flywheel
26 spline input shaft upgrade
(pilot bearing, release bearing)
Rear End:
MM Aluminum IRS bushings
MM Subframe Connectors
Ford Racing Diff Cover
3.73 Gears
Overhaul trak lok with cf clutch
I will supply all the parts just need someone to install them. Would also get my fuel upgrades and blower swap done, but I'd rather not drive to my tuner without a tune. I would just get it done by him to get it tuned right away.
Last edited: