• Welcome to SVTPerformance!

Viper T56 - Built and includes Mod engine bellhousing

Discussion in 'Engine/Drivetrain' started by Hkaiser83, Jun 10, 2010.

  1. Hkaiser83

    Hkaiser83 I am Captain Dynaball. Established Member

    Messages:
    720
    Joined:
    Jan 4, 2009
    Location:
    Houston
    This is not a "Viper Spec" T56, this is an actual Viper T56 that has been modified to bolt up to a Ford Modular engine. This is about as built as a 6 speed comes.
    - 26 spline input shaft
    - Carbon fiber syncros
    - 3/4 Steel Shift Fork
    - 3/4 Billet Key Kit
    - Viper O/S Seal
    - Bronze Pads 1st-4th
    - Bronze Pads 5th-6th
    - Steel TOB retainer
    - All new seals
    - Pro 5.0 Shifter
    - 30 Spline Output Shaft
    - Dynotech Aluminum Driveshaft

    This entire setup has less than a mile on it.

    Comes with a modified crossmember and spacers since the Viper trans mounts different. Also comes with adjustable clutch cable and firewall adjuster.

    $2400 + shipping obo
     
  2. theoneandonly

    theoneandonly New Member Established Member

    Messages:
    5
    Joined:
    Jun 16, 2010
    Location:
    houston
    do you still have the tranny?
     
  3. Jerry03cobra

    Jerry03cobra Active Member Established Member

    Messages:
    1,206
    Joined:
    Oct 5, 2008
    Location:
    Baytown,TX


    I think he sold it allready.
     
  4. Hkaiser83

    Hkaiser83 I am Captain Dynaball. Established Member

    Messages:
    720
    Joined:
    Jan 4, 2009
    Location:
    Houston
    Jerry is correct, this trans is sold.
     

Share This Page