TVS 3.0 pulley guys in here, Boost ?

[cj428mach]

I was a little over 15psi on the 3.0 pulley. I have Kooks LT and high flow cat. Air quality (elevation, dew point, humidly, ect) can influence boost output.

Glad to hear its running now. I have a 2.8" pulley if you need more boost

 

[blownfox]

Glad to hear its running now. I have a 2.8" pulley if you need more boost

Yeah it was the start up tune that was bad. I'm not sure the car will take any more boost. The fuel pumps were only seeing 12.5v at WOT (not sure if that is normal) and the fpdc was almost maxed out. The is a blast to drive and the tune is almost dialed in.

 

[ruthless]

I dont know guys. I tripple checked and I am just about 15.5psi on a hard pull. I guess when the time comes I will just swap out the pulley for a 2.9 or 2.8. I guess boost is just a measurment of restriction so the better the engine breaths the lower the boost but higher the power.

 

[whitedevil95]

As a follow up yeah with my mods and long tubes i was seeing in the mid-low 15s for Boost. I ended up swapping to a 2.8 pulley and and now seeing right at 17psi.

 

[Senkak]

Temecula is a bit over 1000' above sea level. You will loose roughly 1lb of boost for each 1000' of elevation.