Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
New Edge Cobras
Thinking about picking up a T56
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="99COBRA2881" data-source="post: 3185075" data-attributes="member: 12178"><p>I havent done the swap you described but I do have some measurements for you from one of my old posts.</p><p></p><p>Measurements were taken from center of u-joint to center of u-joint on both driveshafts.</p><p>99 stock d/s length 44.5"</p><p>99 T56 aluminum d/s length 44 1/8"</p><p></p><p>*This measurement on the aluminum d/s is very very close, but I wont say its exact. I was laying under the car with the left rear up on a jackstand. Although, I did measure twice to double check the length. </p><p></p><p><a href="http://www.svtperformance.com/forums/showthread.php?t=237221&highlight=driveshaft" target="_blank">http://www.svtperformance.com/forums/showthread.php?t=237221&highlight=driveshaft</a></p><p></p><p>I would say that you might not even need to take off an inch, I'd start with 1/2", see how it fits and go from there. You can always cut more off if need be. </p><p></p><p>hth</p></blockquote><p></p>
[QUOTE="99COBRA2881, post: 3185075, member: 12178"] I havent done the swap you described but I do have some measurements for you from one of my old posts. Measurements were taken from center of u-joint to center of u-joint on both driveshafts. 99 stock d/s length 44.5" 99 T56 aluminum d/s length 44 1/8" *This measurement on the aluminum d/s is very very close, but I wont say its exact. I was laying under the car with the left rear up on a jackstand. Although, I did measure twice to double check the length. [url]http://www.svtperformance.com/forums/showthread.php?t=237221&highlight=driveshaft[/url] I would say that you might not even need to take off an inch, I'd start with 1/2", see how it fits and go from there. You can always cut more off if need be. hth [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
New Edge Cobras
Thinking about picking up a T56
Top