Terminator block

[mgt351]

I have a terminator short block with a cracked cylinder. My question is there a difference in this block vers a 2v Romeo block? I’m asking specifically about engine blocks and not the shortblock. Before I scrap this block is there anything terminator specific I should remove?


Sent from my iPhone using Tapatalk Pro

 

[P49Y-CY]

i'm pretty sure the terminator just used the regular production iron block, but if you scrapping yes i would remove everything that was bolted on, rear main seal, oil pump, etc

 

[SID297]

I'd replace it with this:

5.3L MODULAR STROKER SHORTBLOCK

5.3L MODULAR STROKER SHORTBLOCK|Ford Performance Parts

performanceparts.ford.com

 

[MG0h3]

I'd replace it with this:

5.3L MODULAR STROKER SHORTBLOCK

5.3L MODULAR STROKER SHORTBLOCK|Ford Performance Parts

performanceparts.ford.com

Is there info on what the CR is with different heads? The increased displacement would raise CR even if the dish is the same I suppose.


Sent from my iPhone using the svtperformance.com mobile app