Came across these seats on craigslist last week and really liked the look. I also lucked out and got a set of corbreau seat brackets brand new for $90 that made the install a lot easier. Install wasn't to bad, I had to cut off some brackets on the srt seats and drill two holes in the corbreau brackets to use existing threaded holes on the seat. I wanted to be able to unbolt the bracket but i ended up having to weld the rear part to retain full travel on the sliders.
bottom of seat with brackets
front brackets removed
rears removed
I thread a bolt into the existing threaded hole with the corbreau bracket clamped down to mark the hole location
welds on the top of the bracket also needed to be ground flush to allow it to bolts flat to the seat sliders
Bracket bolted on in the front and welds finished at the rear mount before paint.
Installed
The seats are very comfortable and hopefully will last longer than some cheap race seats being they are an oem seat. Total cost was 390 for seats and brackets.
bottom of seat with brackets
front brackets removed
rears removed
I thread a bolt into the existing threaded hole with the corbreau bracket clamped down to mark the hole location
welds on the top of the bracket also needed to be ground flush to allow it to bolts flat to the seat sliders
Bracket bolted on in the front and welds finished at the rear mount before paint.
Installed
The seats are very comfortable and hopefully will last longer than some cheap race seats being they are an oem seat. Total cost was 390 for seats and brackets.
