SRA issues with UCA fitment... Pic inside!!

[TRQJUNKIE]

Take a look. Went to bolt in the UCA (Steeda) and there is about a 1/4 inch gap on each side of it when centered.Anyone run into this issue?

 

[lowflyn]

Just tighten it down. They'll come together.

 

[04cobra88]

Or use washers as a spacer or make a couple spacers out of pipe

 

[mustang john]

Just tighten it down. They'll come together.

Bingo!

 

[TRQJUNKIE]

I threw in some thinker "fender washers" and it seems to have closed the gap up. Just dumb that these things are made so you have to basically crush the mounting boxes. Thanks guys

 

[fs308]

with team z uppers i had the opposite problem. with the spacers i had to spread the mounting points. was a pain in the ass under the car

 

[ctgreddy]

It's just because it's never been used before. tighten it down and it'll be good to go.