Solid Axle Swap, ABS help needed.

Cobra Command

New Member
Established Member
Joined
Feb 8, 2019
Messages
17
Location
British Columbia, Canada
Hi there, I have a '04 Cobra, that has had a solid rear axle installed. Unfortunately they never set up the ABS. I am looking for help from anyone that has any experience with this. I know the housing has sensor ports, but there are no tone rings on the axles. I am wondering if I can just get away with GT sensors and cables, along with having some Cobra tone rings pressed on the axles.
 

FinnCobra

Member
Established Member
Joined
Oct 18, 2015
Messages
36
Location
Finland
I don't know if this helps, but I swapped IRS in my 1994 Cobra, and used IRS axles sensors with 1994 ABS-module, so sensors and tone rings are similar. Sensors are not mechanically similar.
 

apex svt

MEAN STREAK
Established Member
Joined
Jun 29, 2012
Messages
2,160
Location
USA
Bolt in the gt sensors, and gt rings. You don’t need to press them on, heat them up real good with a hand torch and slide them on. It’s amazing how a little heat allows them to slide right on.
 

Users who are viewing this thread



Top