What is are people putting in the injector comp bait volt section for the FIC 1000cc injectors. Most of the injector data has it in (sec) and the prp has it as a multiplier. For example the FIC 1000 has the value at 14 volts listed as .00115. Do you just move the decimal over 2 to the right?
Putting injector data in SCT PRP
- Thread starter black01bullitt
- Start date
yep
also the injector high slope needs to be set to 0.008333 in all tunes and that makes your scaling percentage
also the injector high slope needs to be set to 0.008333 in all tunes and that makes your scaling percentage
Should that have been 3 decimals over to make it 1.15 in the multiplier table?
Could you explain a little more on the high slope? Wouldn’t I set that to what they have in their data?
read it on my site
Users who are viewing this thread
