Pulling supercharger help!!!

[04COBRAJRxx]

Hey everyone so my friend and i have decided to pull off the supercharger on my 04 cobra and inspect/remove the torque plate.....We have run into a little snag...literally. Were not sure what is holding it on still we have removed all the proper lines and bolt to remove it however somewhere inside on the front half its getting snagged....it kind of has a little spring noise when i pull it up could use some info ASAP being that we are mid removal. THANKS!

 

[BSXrad]

Are you pulling off with the intake manifold still bolted to the motor or as an assembly with the blower?

 

[04COBRAJRxx]

we have the intake and everything disconnected from the supercharger

 

[Termilvr]

Are you just pulling the blower or the blower and lower intake?

Sent from my Kindle Fire using Tapatalk 2

 

[04COBRAJRxx]

just the blower

 

[myponyjose]

If you follow the inter cooler reservoir top hose you are going to see them attached to the lower intake. You need to remove the part where the hoses attach to.

 

[Termilvr]

If you follow the inter cooler reservoir top hose you are going to see them attached to the lower intake. You need to remove the part where the hoses attach to.

+1 you need to remove the intercooler manifold

Sent from my Kindle Fire using Tapatalk 2

 

[04COBRAJRxx]

+1 you need to remove the intercooler manifold

Sent from my Kindle Fire using Tapatalk 2

Sounds good got the same information from about 3 different sources and all including u guys have said the same thing.. thanks for the help will let you know of the turn out

 

[04COBRAJRxx]

^^SHES FREE!!!

^^torque plate has already been removed