The AC lines were shortened by about 1 1/2" width wise.
Project Coyote Notch interior swap IRS CA smog legal
- Thread starter RRRCobraSC281
- Start date
- Status
Some pics of the upper and lower radiator supports.
Had them powder coated at All Bay Coatings in Fremont.
Had them powder coated at All Bay Coatings in Fremont.
Finished installing the headliner, dome light and overhead console. So amazed that the 2013 overhead console fit as good as it did. Also trimmed the rear deck cover for the 3rd brake light.
I was hopping that you were holding back on us. That thing is going to be off the chain when it's done. I wish that I could go to Knotts but the timing won't work, should be a good time.
Spent the weekend aligning stuff. Looks like for it to be perfect the hood needs to be trimmed a little. But good enough to move forward.
Here's what it looks like so far.
This week, plans are to get the driveshaft installed, exhaust installed and bleed the brakes.
Where did you get the grill delete?
CDC grille delete kit from LateModelRestoration
Last edited:
Looking good
I thought my build was a lot of work. wow. Great build man, looks great!
What seats are you using?Finished installing the headliner, dome light and overhead console. So amazed that the 2013 overhead console fit as good as it did. Also trimmed the rear deck cover for the 3rd brake light.
I'm using the factory seats that came on the 2013 Mustang GT equipment withe upgraded seats.
Are you going to have to trim or modify the panels to make them work?
If you are referring to the door panels, look back a bit and you'll see that I've already mocked up a door panel to work.
The interior quarter panels are going to fit just fine. Just need to strip them and paint them to match.
Right now I'm trying to figure why the dome light and courtesy light stay on. Plus the windows are not going up and down normally.
Fun stuff....
Last edited:
I was referring to the rear quarters. I wasn't sure if there would be unusual gaps between the seats and inside panels.
When I get those quarter in I'll put the rear seats in and take them to the upholstery shop and have them complete the rear deck rear seats and redo the rear seat bottom. They will also recover the door panels to match the dark charcoal graphite interior. They will also rework the carpet. But for now priority is the get the door functions and lighting working as it should. The other stuff can be done at a later date.
I got ya. You have some skills my friend!
- Status
Users who are viewing this thread
