Just thought I'd throw some pics up of the exhaust I had done. It's a mix and match of 3" over the axle pipes, Roush AB's and JBA X pipe and cat deletes. I added in some flex's and remove the restrictions. Only neck down I have now is the mufflers are 2.5'' ID. But being that there is two of them I don't forsee that being an issue for <650whp.
Here you can see the additional wideband I added. Kept it on this bank just because #8 is included in it. I'm not relying on this AFR, obv stock sensors are still in place, just nice to have a reference.
pass side
OTA's
Ota again
And the Roush Muffler. Pass side needs a tweak to sit center in the cut out, but overall I think it came out real good.
Here you can see the additional wideband I added. Kept it on this bank just because #8 is included in it. I'm not relying on this AFR, obv stock sensors are still in place, just nice to have a reference.
pass side
OTA's
Ota again
And the Roush Muffler. Pass side needs a tweak to sit center in the cut out, but overall I think it came out real good.