Parting Out Kennebell 2.8H Complete Car Built 2V

90coupe5oh

New Member
Established Member
Joined
May 6, 2009
Messages
282
Location
Greenville
I bought a cobra, so I'm parting this car out. It's a built 2V with a TKO600 and a Kennebell 2.8. I'm parting out everything, full exhaust, etc. If you would like any pictures or prices. Call me or text me at 585-469-4945.

Thanks,
Josh

All of these parts have less than 1500 miles on them.

BBR 2V SOHC 284cid Short block SOLD
8.8:1 Compression Ratio
Kellogg Crank
Diamond Pistons
Manley Rods

BBR 2V CNC Ported PI Race Heads $700 OBO
MPH Cams - Custom Grind for KB
Manley +1mm Valves
Comp Cams Beehive Springs
Cloyes Gears
NEED ONE VALVE

Kenne Bell 2.8H SOLD
JLT Carbon Fiber High Boost Cold Air Intake
3.50" blower pulley
10% over drive crank pulley

Mellings High Volume Oil Pump SOLD

Moroso Oil Pan SOLD

Kooks 1 3/4" Longtubes w/ 3" collectors $600 OBO


TKO 600 Trans SOLD
Steeda Triax
McLeod Twin Disk Clutch system

Stock 8.8 Welded Axle Tubes SOLD
3.55 gears

Steeda upper & lower control arms SOLD

Team Z Motorsports Anti-Roll Bar SOLDr

Team Z Motorsports Aluminum Drag Wing $200 OBO

Aluminum Driveshaft SOLD

2001 Mustang GT Roller SOLD
Team Z front suspension
No hood or front bumper
10pt cage certified to 8.50's
Car is in very good shape.

002-2.jpg


photo11.jpg
 
Last edited:

Brutal DSG

Angry Turtle
Established Member
Joined
Jan 27, 2010
Messages
694
Location
rockland
Do you have the expansion tank support rod? It goes from the bottom of the rad support up to the Coolant Expansion tank
 

Users who are viewing this thread



Top