PA Built 4r70w, PI 3 disk converter, lots of manual to auto swap parts!

4sdvenom

Never Enough!
Established Member
Joined
Dec 2, 2003
Messages
2,439
Location
Ft. Wayne, IN
SOLD

Selling my 4r70w that I've had in my 2003 Cobra for the last 4 years!

Total of 6400 miles on all parts below

Only 1500 miles since tranny was completly gone thru by Performance Automatic with the car at their shop!

Package deal consists of:

-Performance Automatic built 4r70w, best of everything in it.
-Performance Automatic manual valvebody
-Transbrake
-Electronic Overdrive (engaged with toggle switch)
-Electronic Converter lock-up (engaged with toggle switch)
-Performance Automatic Deep aluminum tranny pan with drain plug
-Tranny fluid fill tube and dipstick
-Precision Industries 3-disc lock-up converter (currently a 4000 flash stall, 4500 TB stall, and 3200 foot brake stall)
-Performance Automatic 8-bolt SFI approved flexplate
-All flexplate to crankshaft bolts
-All converter to flexplate bolts
-4r70w block plate
-Converter inspection cover and bolts
-All bellhousing to engine bolts
-4r70w transmission crossmember
-Two B&M Supercooler transmission coolers (big ones with 1/2" npt connections)
-Custom built to length Driveshaft built by Denny's Driveshaft with high speed balance (1330 U-joint on front, and 1350 U-joint with '03 Cobra pinion flange on rear).

Tranny and converter purchased brand new from Hermann @ HBH, all other parts purchased brand new from Ford, or listed vendor!

I have over $6800 (if not more) invested in the above items!

$3800 for everything above - picked up or meet up withen 2.5 hours of Ft. Wayne, IN!


Thanks,
Ken
 
Last edited:

Users who are viewing this thread



Top