Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Mustang Forums
2015+ S550 Mustangs
5.0L Coyote V8 Engine Modification/Discussion
OPG's, pulleys and shift points for whipple 2.9
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gt347mustang" data-source="post: 15898387" data-attributes="member: 44328"><p>Helping a friend dial in a 2017 auto car.</p><p></p><p>Only mods are gen 3 Whipple, 132mm tb, long tubes and supporting fuel. Currently running 3.25" pulley but plan to run the smallest possible upper without belt slip on stock 6 rib lower.</p><p></p><p>Current shift point is 7000 for fear of shattering factory opg's. Would like to rev it as high as safely possible after installing gears. My question is how high could we turn it once the gears are installed; and what upper pulley can we run without slipping at 7500+rpm on the 6 rib?</p><p></p><p>Haven't had it on the dyno yet plan to experiment with different air fuel and timing once it's all assembled. We're currently at 0.82 lambda and 20-23 degrees of timing on e40 fuel and plan to shift both those on the dyno to see what the car actually likes.</p><p></p><p>Any input from those with a similar combo would be appreciated. We just want to make sure we're headed in the right direction with mods before pulling the trigger on gears and pulleys.</p></blockquote><p></p>
[QUOTE="gt347mustang, post: 15898387, member: 44328"] Helping a friend dial in a 2017 auto car. Only mods are gen 3 Whipple, 132mm tb, long tubes and supporting fuel. Currently running 3.25" pulley but plan to run the smallest possible upper without belt slip on stock 6 rib lower. Current shift point is 7000 for fear of shattering factory opg's. Would like to rev it as high as safely possible after installing gears. My question is how high could we turn it once the gears are installed; and what upper pulley can we run without slipping at 7500+rpm on the 6 rib? Haven't had it on the dyno yet plan to experiment with different air fuel and timing once it's all assembled. We're currently at 0.82 lambda and 20-23 degrees of timing on e40 fuel and plan to shift both those on the dyno to see what the car actually likes. Any input from those with a similar combo would be appreciated. We just want to make sure we're headed in the right direction with mods before pulling the trigger on gears and pulleys. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Mustang Forums
2015+ S550 Mustangs
5.0L Coyote V8 Engine Modification/Discussion
OPG's, pulleys and shift points for whipple 2.9
Top