Hey everybody I need some wiring info. I have a '12 gt (6 speed) using nx plate kit with a 150 shot. It already has a full throttle switch but I'm also putting a window switch on for added safety. I got the summit racing brand window switch (p/n 430452). It has 4 wires. Red ( main 12v switched source), black (ground), grey (tach signal), and blue connects to ground side of the device you want to activate at a certain rpm.
I have the ground hooked up.
Red 12v source is connected to my nitrous arming switch.
Grey wire is hooked to cylinder 8 coil. (Not the ground side)
Blue wire is hooked to the ground side of my fuel pressure safety switch.
My nitrous is still activating as soon as I'm at 100% throttle. I have the controller set to activate at 4,000 rpms and deactivated at 6,800 rpms.
Does anybody have any information whatsoever to help me out? I tried searching but really couldn't come up with too much. Any help would be greatly appreciated thank you!
I have the ground hooked up.
Red 12v source is connected to my nitrous arming switch.
Grey wire is hooked to cylinder 8 coil. (Not the ground side)
Blue wire is hooked to the ground side of my fuel pressure safety switch.
My nitrous is still activating as soon as I'm at 100% throttle. I have the controller set to activate at 4,000 rpms and deactivated at 6,800 rpms.
Does anybody have any information whatsoever to help me out? I tried searching but really couldn't come up with too much. Any help would be greatly appreciated thank you!
