New wheel/tire post (19x11 square)...

11Sec_Lx

Well-Known Member
Established Member
Joined
May 31, 2003
Messages
3,098
Location
Indianapolis
19x11 (+56) square - Forgestar CF5's

295/35 Falken RT660's (SCCA Solo legal)

Ford Racing Hubs w/ARP studs

OP Mustang hubcentric spacers (16mm)

Alignment: -2.6*/-2.7* camber, 7* caster, 0 toe

These are rotatable and have been confirmed to be able to be ran in both directions.

The rear fit is unreal. The wheel almost touches the dust boot of the shock. Then, on the outside, the wheel is tucked in by 1/4" from the outside wheel lip. Such a nice, finished, mature appearance.

The fronts are tucked in by 1/2" or so. Again, a very finished appearance.

So far I'm astounded by these tires. I haven't been on an SCCA Solo course with them yet, but have played around on the street and have I can't say enough about them. After 30 minutes of spirited driving on back roads and roundabouts, I tried a second gear roll on concrete. They held it, didn't spin an ounce! I am pullied down a hair from the 1101, but it's still over 1000 and they stuck like glue.
41e0e5a004109838b5d5b709381dc444.jpg
167558b7624076bfe43bd0f2179a557a.jpg
cbe42b88143f1325e41329b7a64b985e.jpg
f04093f4ddf0c1c78c8e6b85dc1aa08b.jpg


Sent from my SM-G988U using Tapatalk
 
Last edited:

Users who are viewing this thread



Top