new to poly motor mounts

[v6cobra]

i just bought some poly mounts for my cobra from Americanmuscle.com and was wondering if any one could tell me what i should torque these bolts down to. thanks



Uploaded with ImageShack.us

 

[olgreydog7]

I'm pretty sure they are preloaded from the factory.

 

[v6cobra]

thats what i thought too but when i ordered them the nuts were barely a 1/4 turn on to the bolt. one of the bolts wasnt even on the mount. i found it rolling in the box.

 

[Lightning&Mach1]

If i remember right I just tightening mine as much as I could with it in a vice. Those are nylon locking nuts, so I dont see them backing off. I havent had problems with mine either.

 

[gmsux]

I ran them down till the two plates were touching. No problems.

 

[powershifter]

Call american muscle or the manufacturer and ask

 

[v6cobra]

Thanks guys

 

[DHG4410]

If i remember right I just tightening mine as much as I could with it in a vice. Those are nylon locking nuts, so I dont see them backing off. I havent had problems with mine either.

Did the same, tighten them down. Good question though.

 

[VirtualSVT]

That's weird as hell. When I bought mine they were good to go from the factory. They had a small gap between them. Quarter inch maybe?

5 years no problems..