New Mod - Aeroforce 3.5 bar map sensor

[cobracide]

Just installed the Aeroforce 3.5 bar map sensor. Works very good, fairly easy to install and is accurate. Have the overlay on the stock gauge as well and they correlate to the same readings. Wanted to see the max boost readings and see if it's over 16 lbs (overlay's limit). I can take some pics and help out anyone with the install.

 

[MVD]

Is this any different than the GM 3-bar MAP sensor (like used with the SCT software)? Does it use a 0-5V output signal?

 

[cobracide]

The 3.5 map sensor outputs standard 0-5v, requiring a 12v power source. You input a slope of -14 and initially an intercept of 0. You then change the intercept so the gauge reads 0 when key on engine off.