Need quick KB BAP install help...

[fullboogie]

I just started my KB BAP install on my '07. Got fuses installed under the hood, and now I'm in the trunk. The problem I'm having is that KB's instructions refer to the "large red wire" coming from the driver's side and going to the passenger side fuel pump driver. There are TWO large red wires heading in that direction, and the connector on the passenger side fuel pump driver has TWO large red wires going into it. I'm following this install guide (http://www.svtperformance.com/forums/how-279/596634-kenny-bell-dual-boost-pump.html) but it is not helping.

Can anyone clear this up for me? I sure would like to get this wrapped up so I can try out my new TVS.

 

[zporta]

So both of the red wires are going into the FPDM connector? That photo in the writeup only shows one. And I'm pretty sure mine only had one

 

[fullboogie]

Yep - there are two large red wires going into the passenger side fuel pump driver.

 

[Van@RevanRacing]

Problem solved.

 

[zporta]

Do both wires come all the way from the fuse box? Or is one of the red wires a jump wire?

The instruction say red wire coming to fuse box to FPDM

 

[zporta]

Van to the rescue

 

[enormous]

Problem solved.

What solved it?
I'm just wondering since I plan to order a Bap from Van and wire it into my 08 this winter. My 13 TVS installed on my 08 is thirsty at times.

 

[Van@RevanRacing]

I walked the OP through his wiring and how to back trace the FPDM power wire for the second FPDM.

 

[fullboogie]

Ford can suck it for using the same color wires everywhere!

Van - thanks for taking my call and helping out.