So I have a SCT SF3 and am trying to datalog AFR on LiveLink with my Innovate MTX-L. I don't know exactly how to do the formula, and where to input it. Do I enter the formula on the SF3 itself, or do I input the formula on LiveLink?
I've got the 6pin fire wire hooked up to the ground and the Analog Out (0-5v) wire of the wide band and into the hand held using the below diagram (black and orange wires)
So i know:
0v = 7.35 AFR
5v = 22.39 AFR
So when I go to setup the analog on the SF3: I go to Setup Analog Input > Channel 1 > WideBand > Custom WB > Select Format: (V*a)+b > Enter Value for 'a' 7.35 > Enter Value for 'b' 22.39
When I finish entering that formula, and I select "Analog 1" from my PID list on Livelink nothing is showing up.. What gives? :fm:
How to from SCT:
How to figure out an Analog Wideband Formula. - SCT SupportSuite
Innovate MTX-L Instructions:
http://www.innovatemotorsports.com/support/manual/MTX-L_Manual_1.1.pdf
I've got the 6pin fire wire hooked up to the ground and the Analog Out (0-5v) wire of the wide band and into the hand held using the below diagram (black and orange wires)
So i know:
0v = 7.35 AFR
5v = 22.39 AFR
So when I go to setup the analog on the SF3: I go to Setup Analog Input > Channel 1 > WideBand > Custom WB > Select Format: (V*a)+b > Enter Value for 'a' 7.35 > Enter Value for 'b' 22.39
When I finish entering that formula, and I select "Analog 1" from my PID list on Livelink nothing is showing up.. What gives? :fm:
How to from SCT:
How to figure out an Analog Wideband Formula. - SCT SupportSuite
Innovate MTX-L Instructions:
http://www.innovatemotorsports.com/support/manual/MTX-L_Manual_1.1.pdf