MMR's new Billet Rear Main Cover / Block Support for all 2011-2016 5.0 Coyote blocks

Modular Racing

Authorized Vendor
Authorized Vendor
Joined
Jun 28, 2004
Messages
15,176
Location
877 MOD POWR
MMR's new 5.0 Coyote Billet Rear Main Seal Housing/Block Support for all 2011-2017 Blocks. This new 1/2 plate from MMR yields 69% higher strength than the Cast aluminum OE part. This means not only is it stronger but supports the rear of the block and rear main cap better. A Lower friction 1 piece rear main seal is include along with hardware. The factory Crank trigger and sensor bolt on just like factory but with a thicker and stronger locating boss for rock solid Ignition timing.

Available now with INTRODUCTORY pricing for just $99.99 here>> http://www.modularmotorsportsracing...page=product_info&cPath=26_27&products_id=856


110335_.jpg


110335_001.jpg
 
Last edited:

Torchy

Well-Known Member
Established Member
Joined
Dec 20, 2012
Messages
1,478
Location
Earth
Anyone using this on the street?

MMR does this put the factory crank trigger and sensor in the exact stock location?
 

Modular Racing

Authorized Vendor
Authorized Vendor
Joined
Jun 28, 2004
Messages
15,176
Location
877 MOD POWR
It is designed for stock cars all the way up to 2500HP coyote engines - street or strip, in regards to sensor location - It certainly does, this is a critical dimension and not based entirely on the rear cover since it bolts to the block itself (and not the mmr part) and simply slides down through the mmr plate. The location however in simple terms is identical.
 
Last edited:

Users who are viewing this thread



Top