NW_Wildman
New Member
has anyone here made a Mach 1 engine and trans run standalone? I recently acquired a wrecked 2003 Mach 1 and I intend to swap the drivetrain into my '59 F100 but haven't seen much information online about this engine/trans combo being used as a standalone setup of being swapped into an older chassis.
Everything I am seeing is a lot of 2v to 4v swap threads. with enough time I'm sure I can pare-down the factory harness to work but whooooo will that be a ton of time... not to mention I haven's seen a lot in the way of wiring diagrams for the engine/fuel system/dash for the Mach.
Any input would be appreciated. Thanks!
Everything I am seeing is a lot of 2v to 4v swap threads. with enough time I'm sure I can pare-down the factory harness to work but whooooo will that be a ton of time... not to mention I haven's seen a lot in the way of wiring diagrams for the engine/fuel system/dash for the Mach.
Any input would be appreciated. Thanks!