• Welcome to SVTPerformance!

Long Tube Woes

Discussion in 'Exhaust' started by 05Frlndr, Dec 11, 2013.

  1. 05Frlndr

    05Frlndr Member Established Member

    Messages:
    58
    Joined:
    Nov 7, 2010
    Location:
    Midland, Texas
    Has anyone used their longtubes with the FRPP Boss 302 H-pipe?

    Thanks

    -JRP
     
  2. INEEDA_TERMI

    INEEDA_TERMI Member Established Member

    Messages:
    681
    Joined:
    Sep 7, 2011
    Location:
    Grady, Alabama
    Unless you're running the jpc headers i ddon't see how it would work without cutting. I think kooks makes a version to work with their headers.
     
  3. JohnRichard

    JohnRichard MT82 Speed Shiftin Maniac Established Member

    Messages:
    312
    Joined:
    Oct 29, 2013
    Location:
    Oklahoma City
    I looked at this... I have a Boss with other then factory exhaust header... the header spacing center to center is just a little wider than the Boss 302 H-pipe center to center on the inlet side... so if you found a muffler shop that would mate the two without cats it would work... The only reason I did not like it... going from a 3 inch collector to 2 1/4 / 2 1/2 pipe just for side pipes... side pipes,,, really? Ill pass, just give me 3" out the back and the Corvette drivers can have their side-pipes.
     
    Last edited: Dec 12, 2013
  4. Ultrakla$$ic

    Ultrakla$$ic WhoFlungPoo Established Member

    Messages:
    1,870
    Joined:
    Aug 16, 2010
    Location:
    Louisiana
    Good luck!!!! I comtemplated it for a whole year and it would have taken some decent amount of fabbing without actually buying the CRAZY:kaboom: expensive Kooks setup. Dumped the Boss H-Quad setup and went Stainless Works longtubes and glad I did. You couldn't hear the Quads anyway and I ran them wide open.
     

Share This Page