Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
How-To
Liberty 26 Spline Input Shaft Installation,,,Pix!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="five 0 ninja" data-source="post: 10689257" data-attributes="member: 74376"><p>I have the tranny out to do the clutch. Also bought the lethal bearing retainer. Never really worked on tranny internals. Trying to figure out exactly what needs to be done to replace the sleeve and what I will need. Sounds like I unbolt the front of trans. Will anything be falling out at that point like bearings or races or anything? Then I simply hammer out the old bearing retainer? Will seals or anything need to be removed seperately? Then hammer new retainer in with a socket? Is everything needed to seal already installed on the lethal retainer when you recieve it? Then I put some black or grey rtv sealant on front cover and bolt it back on? No need to mess with the input shaft or shims or anything else? Thanks</p></blockquote><p></p>
[QUOTE="five 0 ninja, post: 10689257, member: 74376"] I have the tranny out to do the clutch. Also bought the lethal bearing retainer. Never really worked on tranny internals. Trying to figure out exactly what needs to be done to replace the sleeve and what I will need. Sounds like I unbolt the front of trans. Will anything be falling out at that point like bearings or races or anything? Then I simply hammer out the old bearing retainer? Will seals or anything need to be removed seperately? Then hammer new retainer in with a socket? Is everything needed to seal already installed on the lethal retainer when you recieve it? Then I put some black or grey rtv sealant on front cover and bolt it back on? No need to mess with the input shaft or shims or anything else? Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
How-To
Liberty 26 Spline Input Shaft Installation,,,Pix!!
Top