Lexan Drag Grille?
- Thread starter lightitup
- Start date
I know DMP has them, or you can go to Home Cheapo and make one yourself.
i made the upper and lower drag grill and one ended up breaking i used plexiglass.I am going to try again with a different materal. it was easy to do though and cheap
Cardboard or that plastic that they make signs from. The kind that stick up beside the road. I made a cardboard one for a template and had the plastic one made, but used the cardboard one a few times. Just tape it on.
You want one of these, don't you?
Its from DMP...
Its from DMP...
You want one of these, don't you?
Its from DMP...
Damn, me like!!!
DMP's site is down, how much are they sold for?
way to much
They did a group purchase on them a while back.
For the life of me I can't remember how much I paid....
EDIT:
I just did a little search through my PM's, to find an answer to as how much they cost.
It's right around the 275.00 dollar mark....
For the life of me I can't remember how much I paid....
EDIT:
I just did a little search through my PM's, to find an answer to as how much they cost.
It's right around the 275.00 dollar mark....
Last edited:
Is their any chance that you have some pics of the backside. Curious to what holds it on and how hard it would be to make.
I would to ask Stan about that. Its a DMP product.
Last edited:
Yes that is the one. Thanks for the info everyone :beer:You want one of these, don't you?
Its from DMP...
Ditto, because you can get sheets of Lexan at Home Depot/Lowes and make your own if your DIY'er. WOuld definitly save you a quite a few bucks if you have the proper tools. I may try this, but will have to figure out how to affix it to the grill.
Users who are viewing this thread
