LED question

[03cobraracer]

Hey guys looking to spruce up some lighting in my car mainly the dome light inside,and license plate lights. Idk where else to swap out the normal bulbs for led. I hate the dome light mainly it's terrible. Any good places to get good LED's for cheap?

Also anywhere else you would suggest changing bulbs out? Thanks.

 

[03 Indy Cobra]

I haven't ordered anything from them but they seem reasonable. Check this link out.

http://www.diodedynamics.com/store/listed-by-vehicle/ford/mustang-link/svt-cobra.html

 

[maple]

Without a doubt Diode dynamics. I have a complete set of bulbs at the house awaiting to go in the car when I get it back.

 

[WheelStander]

Got mine from Pep Boys, they have em all...

 

[03cobraracer]

Ok cool thanks guys. Time to make this thing look more modern and actually be able to see in my car at night

 

[Dip Dungles]

Take a look at Vleds.com. Some of the best on the market. All of my cars run them.

 

[Kyle_KleinSS]

Got all mine on ebay. Every light on my cobra and F350. Had them over a year no issues. I think I got a 10 pack of the dome light bulbs for 5 bucks. You need 3 each anyways. Turn signals I had to get the pilot bulbs from walmart cause they threw the turn signal bulb out code.

 

[Gotmysvtcobra03]

Take a look at Vleds.com. Some of the best on the market. All of my cars run them.

These bulbs are a direct install right? If so I'm very interested!


Sent from my iPhone using Tapatalk

 

[Dip Dungles]

For license plate bulbs you need the following
http://www.vleds.com/shop-application/license-plate-lights/194-158-168.html

The dome lights will need to be angled do to the circuit board but they are bright enough so you wouldn't notice.

If I had my Cobra I would take a pic for you but it's at the shop.

 

[Gotmysvtcobra03]

For license plate bulbs you need the following
http://www.vleds.com/shop-application/license-plate-lights/194-158-168.html

The dome lights will need to be angled do to the circuit board but they are bright enough so you wouldn't notice.

If I had my Cobra I would take a pic for you but it's at the shop.

What do you mean "angled"?


Sent from my iPhone using Tapatalk

 

[Dip Dungles]

Instead of the circuit board facing either directly down or up you need to turn it to the side so that the board clears the housing.

 

[Gotmysvtcobra03]

Instead of the circuit board facing either directly down or up you need to turn it to the side so that the board clears the housing.

Gotcha, so i basically a matter of turning it sideways?


Sent from my iPhone using Tapatalk

 

[Dip Dungles]

Yessir

 

[WheelStander]

I did my whole car with some from Pep Boys they were all Plug and Play, no angles or what not.

 

[mstangtony]

I actually bought all my LEDs for my Cobra from Superbrightled.com they maybe cheaper too, however you need to know what your looking for. just know the bulb size and the fit. its not that bad.

 

[Huachipato]

I put a small RGB LED in the foot well. Can't upload this pic to Photobucket for some reason - but lighting the foot well has helped light up my car immensely.

https://goo.gl/photos/DTt8bBLoddSRDRwZA - link in case the image doesn't show

 

[WheelStander]

Added footwell led as well all the rest blue led