• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

Leaking axles seals moser axles?

Discussion in 'Driveline' started by jdgt03, Feb 24, 2013.

  1. jdgt03

    jdgt03 Member Established Member

    Messages:
    687
    Joined:
    Apr 29, 2005
    Location:
    Florence Al.
    I've got my car up and going good and yesterday I notice gear oil under my back left tire. So I pulled both axles and sure enough there leaking. I have moser 33 spline axles 9inch ends and the axles use an o ring on the bearing. We're can I get this o ring and and tricks on making sure it doesn't leak again?
     
  2. JDUB348

    JDUB348 Active Member Established Member

    Messages:
    1,192
    Joined:
    Jul 10, 2011
    Location:
    Lake Stevens, Washington
    I'm not the most knowledgeable person about C clip eliminators, but i do think thats one of the draw backs of running a non c clip axle?
     
  3. jdgt03

    jdgt03 Member Established Member

    Messages:
    687
    Joined:
    Apr 29, 2005
    Location:
    Florence Al.
    Well I would say that but I have 9 inch housing ends which is different. I guess I'll just get the o rings and seal it up.
     

Share This Page