Searched all over the internet for some pictures or a how to for taking apart a snout and replacing bearings. Blower is a 2.0 KB with a snout upgrade.. (confirmed the blower with KB) The only thing I found was an old thread on a Dodge forum. According to that, the shaft should come out the back end. Tapped on it with a driver and hammer, no luck. So I put it in the press. Put some pressure on it and the pulley end moved but the other end did not. I stopped so I don't destroy it.
So I'm looking for some advice on how to proceed. Anyone have experience replacing the bearings?
So I'm looking for some advice on how to proceed. Anyone have experience replacing the bearings?