K-member brace

[budlightman4u20]

I'm looking for a k-member brace to bolt up to the factory k-member. I had a 4 point MM brace but I had to put the factory one back on when I installed my new tremic t56 magnum with a QuickTime bellhousing. The 4 point brace was hitting the bellhousing hard couldn't even get it to come close to bolting up. Any help is much appreciated.

Sent from my Pixel 3 XL using the svtperformance.com mobile app

 

[OldYeller]

Stifflers makes one for the factory K. I have it and it installed easy and fit good. It was not 100% bolt on as there were two holes I had to drill iirc.

 

[ZR5.0]

Not able to space it down enough to clear?

 

[budlightman4u20]

Not able to space it down enough to clear?

I thought about doing that and measured up what spacers I would need and it was too much of a drop to even get it off the 4 post lift I had it on and I'm sure it would have dragged the road bc in Illinois we have the worst roads ever

Sent from my Pixel 3 XL using the svtperformance.com mobile app

 

[budlightman4u20]

Stifflers makes one for the factory K. I have it and it installed easy and fit good. It was not 100% bolt on as there were two holes I had to drill iirc.

I'll have to check it out thanks

Sent from my Pixel 3 XL using the svtperformance.com mobile app

 

[52merc]

QA1 makes an OEM K-member brace as well, P/N 52105.

 

[OldYeller]

How much larger Over the factory bellhousing Is yours? My car is up on the lift currently so I could easily snap you a pic and get some rough measurements if you want.

 

[94slowbra1]

I also run the stifflers brace. Like stated above you have to drill 2 holes in the k-member to bolt it up. Good piece and seems to do the job